MOSCHIP MCS7840 USB端口方案
作者: 时间:2008-09-28 09:17 来源:eaw
MOSCHIP公司的 MCS7840是USB到四路串口器件,提供各种标准串行设备连接到USB端口. MCS7840有连接到四个独立UART的USB设备控制器,以及USB 2.0 PHY,电压稳压器,有四个16c450/16c550兼容的UART.支持多种串行通信包括HyperTerminal, PComm, Windows direct connection, Windows dial-up等.可用于串行附属设备,调制解调器,串行鼠标和通用串行设备,串口服务器,数据采集系统和POS终端与工业PC.本文介绍了MCS7840主要特性,方框图以及评估板方框图和详细电路图.
MCS7840 USB-2.0 to Four Serial Ports
The MCS7840 is a USB-2.0 to Quad-Serial Port device. It has been developed to connect a wide range of standard serial devices to a USB host. The MCS7840 has a USB Device Controller connected to four (4) individual UARTs.
Support for the following serial communication programs is included:
HyperTerminal, PComm, Windows direct connection, Windows dial-up connection through modem, Networking over IrDA and Windows direct connection over IrDA, Minicom.
MCS7840主要特性:
USB-2.0 Device Controller
On-Chip USB-2.0 PHY
On-Chip Voltage Regulators
Four 16c450/16c550 compatible UARTs
Supports SIR IrDA Mode on any/all ports
Supports RS-232, RS-485 and RS-422 Serial Ports
5, 6, 7 & 8-bit Serial Data support
Hardware and Software Flow Control
Serial Port speeds from 50 bps to 6 Mbps
Custom BAUD Rates supported through external clock and/or by programming the
internal PLL
On-Chip 512-Byte FIFOs for upstream and downstream data transfers for each Serial
Port
Supports Remote Wakeup and Power Management features
Serial Port Transceiver Shut-Down support
Two-Wire I2C Interface for EEPROM
EEPROM read/write through USB
iSerial feature support with EEPROM
One Bi-directional multi-function GPIO
On-Chip buffers for Serial Port signals to operate without external Transceivers over
short cable lengths
Bus-Powered Device
MCS7840应用:
Serial Attached Devices
Modems, Serial Mouse, Generic Serial Devices
Serial-Port Server
Data Acquisition System
POS Terminal & Industrial PC
图1.MCS7840方框图
图2. MCS7840评估板方框图
图3. MCS7840评估板电路图(1)
图4. MCS7840评估板电路图(2)
图5. MCS7840评估板电路图(3)